Table of Contents
Upgrading your Ford F-250’s exhaust system can significantly improve its performance and sound. One popular choice among truck enthusiasts is the Borla ATAK exhaust. This guide will walk you through the steps to replace your stock exhaust with a Borla ATAK on your Ford F-250.
Tools and Materials Needed
- Socket set and ratchet
- Wrench set
- Exhaust hanger removal tool
- Lubricant spray (WD-40 or similar)
- Jack and jack stands
- Protective gloves and eyewear
- Borla ATAK exhaust kit
Preparation
Start by parking your truck on a flat surface and engaging the parking brake. Use the jack to lift the rear of the vehicle and secure it with jack stands. Wear protective gloves and eyewear to ensure safety during the process.
Removing the Stock Exhaust
Locate the stock exhaust system underneath your truck. Apply lubricant to the bolts and clamps to make removal easier. Use the socket set and wrenches to disconnect the exhaust from the catalytic converter and muffler. Carefully remove the exhaust hangers using the hanger removal tool.
Once all connections are free, carefully lower and remove the stock exhaust system from the vehicle.
Installing the Borla ATAK Exhaust
Compare the new Borla ATAK exhaust components with the old system to ensure proper fit. Start by attaching the new exhaust to the catalytic converter or mid-pipe, securing it with the provided clamps. Use the exhaust hangers to support the system and ensure it is properly aligned.
Connect all sections of the exhaust system, tightening clamps and bolts securely. Double-check that the exhaust is properly supported and not contacting any part of the vehicle.
Final Checks and Tips
Lower the vehicle from the jack stands and start the engine. Listen for any leaks or rattling sounds. Ensure the exhaust is securely mounted and clear of any moving parts. Test drive your truck to experience the improved sound and performance.
Remember to periodically check the exhaust system for tightness and leaks, especially after initial installation.